The table shows the pin configuration of the Arduino UNO–based robotic arm. The red (VCC) wires of all servos are connected ...
If you wanted to build a robot that chased light, you might start thinking about Raspberry Pis, cameras, and off-the-shelf computer vision systems. However, it needn’t be so complex. [Ed] of ...
Here’s something fun from [Chad Kapper] over on HackMakeMod: Escape Room Lockbox with the Cheap Yellow Display. You may have heard of the “cheap yellow display” (CYD), so-called due to the board’s ...
ACEBOTT QD023 is an ESP32-based wearable gesture control glove that tracks finger movements with potentiometers instead of more traditional flex sensors.
The DR44 is a two wire Alternator with a built-in regulator. Well, really three wire but the third wire is not needed if adapting this alternator into another vehicle. The DR44 needs a 5V, 128Hz PWM ...
I2C_PWM_generator is a sketch to change an Arduino UNO in an I2C slave device to control the 6 PWM outputs of the Arduino UNO. One can think of this sketch as a co-processor that handles the 6 PWM ...
Abstract: When the selected harmonic elimination pulsewidth modulation (SHEPWM) is adopted to three-level neutral-point-clamped converters to reduce the switching frequency, the neutral-point ...
Abstract: The three-level Vienna rectifier is an attractive topology for power factor correction applications. However, for practical high-frequency applications, the nonlinearity caused by snubber ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results